Haas Mill M Codes
Код: Выделить всё
M-Code Description
M00 Program Stop
M01 Optional Program Stop
M02 Program End (Setting 39)
M03 Spindle On, Clockwise (S) (Setting 144)
M04 Spindle On, Counterclockwise (S) (Setting 144)
M05 Spindle Stop
M06 Tool Change (T) (Setting 42, 87, 155)
M08 Coolant On (Setting 32)
M09 Coolant Off
M10 4th Axis Brake On
M11 4th Axis Brake Release
M12 5th Axis Brake On
M13 5th Axis Brake Release
M16 Tool Change (T) (Same as M06)
M17 APC Pallet Unclamp and Open APC Door
M18 APC Pallet Clamp and Close APC Door
M19 Orient Spindle (P,R values optional)
M21-M28 Optional User M Code Interface with M-Fin Signals
M30 Program End and Reset (Setting 2, 39, 56, 83)
M31 Chip Auger Forward (Setting 114,115)
M33 Chip Auger Stop
M34 Coolant Spigot Position Down, Increment (+1)
M35 Coolant Spigot Position Up, Decrement (-1)
M36 Pallet Part Ready (P)
M39 Rotate Tool Turret (T#) (Setting 86)
M41 Spindle Low Gear Override
M42 Spindle High Gear Override
M50 Execute Pallet Change (P) (Setting 121 thru,129)
M51-M58 Optional User M Code Set
M59 Output Relay Set (N)
M61-M68 Optional User M Code Clear
M69 Output Relay Clear (N)
M75 Set G35 or G136 Reference Point
M76 Control Display Inactive
M77 Control Display Active
M78 Alarm if Skip Signal Found
M79 Alarm if Skip Signal Not Found
M80 Automatic Door Open (Setting 131)
M81 Automatic Door Close (Setting 131)
M82 Tool Unclamp
M83 Auto Air Jet On
M84 Auto Air Jet Off
M86 Tool Clamp
M88 Coolant Through the Spindle On
M89 Coolant Through the Spindle Off
M93 Axis POS Capture Start (P, Q)
M94 Axis POS Capture Stop
M95 Sleep Mode
M96 Jump if No Input (P, Q)
M97 Local Sub-Program Call (P, L)
M98 Sub Program Call (P, L)
M99 M97 Local Sub-Program or M98 Sub-Program Return or Loop Program (Setting 118)
M101 MOM (Minimum Oil Machining) CANNED CYCLE MODE (I)
M102 MOM (Minimum Oil Machining) MODE (I,J)
M103 MOM (Minimum Oil Machining) MODE CANEL
M109 Interactive User Input (P)PS: Не знаю, как здесь у вас оформить таблицу, поэтому выложил списком.
